I am trying to get the HT programmed for use with the DStar system and then how to actually use the DStar system. I want to be able to do direct connect to DStar repeaters and as well as setup the HT to go through my home internet or another internet source when a DStar repeater is not in range.
The RTSystems program software is a bit confusing with Tone, Tone Squelch, Tone Squelch R, DTCS, DTCS R, D Code, D CTS, D Tone, and Split Tone. Trying to figure out which one I use for a repeater that uses a code on both input and output has been unsuccessful. I will take any assistance and training links you can offer. I have an ICOM ID-52A.
Best regards,
Richard
There was a problem reporting this post.
Please confirm you want to block this member.
You will no longer be able to:
Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.